1988-1998 Silverado/Sierra Chassis

-Our front setups include lock-to-lock turning radius without rubbing the frame rails.
-The control arms allow up to 14.5 inches of lift to help un-tuck those large wheels after laying body.
-A front sway bar(optional) adds to the improved drive-ability of a body dropped truck.
-The parallel rear four link and sleeve air bag suspension creates a stable, yet smooth ride out back.
-A lowered rack and pinion mounting location in conjunction with lowered motor mounts keep steering shaft from binding as well as minimal sheet-metal modifications to your cab floor.

(Normally 4-6 week build time after ordering.)

Each BASE chassis includes:

• Bumper to bumper 2x4 .188" wall chassis rails
• Upper and lower control arms
• Spindles (re-tapered)
• Chromoly heim joint steering kit
• Motor mounts
• Transmission crossmember
• Carrier bearing crossmember (if necessary)
• Parallel 4 link with diagonal trac bar
• (2) Air Lift Dominator D2600 air bags (front)
• (2) Firestone F9100 air bags (rear)
• (4) Monroe-Matic gas charged shocks (lifetime warranty)
• Cab, bed, and core support mounts
• Front and rear bumper mounts

OPTIONAL equipment includes:

• Front sway bar ($750)
• Rear sway bar ($750)
• 23 gallon fuel cell - holds factory pump assembly and utilizes factory fuel door ($550)
• 2 piece drive shaft ($650)
• Rear axle installation - must be shipped to Phat Phabz ($300)
• Rear axle narrowing - new Moser axles replace stock units ($750)